F28 Hull repair

Anything that doesn't fit into the other Physical Systems categories

F28 Hull repair

Postby Jim Evans » Mon Feb 06, 2017 10:01 am

My Freedom 28 (Mull) had a bad grounding a few years back. It has leaked around the back of the keel ever since.
I took up the cabin sole to find the floor had been leveled by pouring a bucket of resin in place. Now there are two fore and aft cracks in the resin behind the keel sump, and the hull is definitely flexing in this area.
I'd like to strengthen by glassing in a substantial grid on the hull behind the keel; the problem is, how do I remove the cracked resin? It's up to an inch thick and apparently well bonded (I whacked at it with hammer and chisel).
Any suggestions?
Jim Evans
 
Posts: 1
Joined: Sat Feb 04, 2017 3:57 pm

Return to Everything Else

Who is online

Users browsing this forum: No registered users and 1 guest