Dripless seal on f35 -- looking for a photo

Engines, Drive trains, Propellers, Steering, Ground Tackle and other mechanical system

Dripless seal on f35 -- looking for a photo

Postby xluke1 » Thu Apr 23, 2015 6:48 pm

Hello,
I am probably looking for a needle in a haystack but I have a leak while running on my PSS dripless shaft seal on my Pedrick F35. On inspection, the retaining collar/seal (the one w/ set screws) is quite far forward. I'm wondering if it has slipped forward allowing tension to come off the bellows, as opposed to some other problem. I was going to try to adjust it aft per PSS's instructions, but wanted to get an idea as to how far aft it should be. Does anyone have a photo of the PSS they coudl send me so I can estimate how far from the shaft to transmission coupler should be from the collar/seal. Right now it is probably less than an inch which makes me wonder if the bellows are under-compressed.

Or, I'm open to other suggestions that may explain why it started leaking at many RPM ranges.

Thanks!!
xluke1
 
Posts: 12
Joined: Mon Apr 16, 2012 7:22 pm

Re: Dripless seal on f35 -- looking for a photo

Postby fmolden » Fri Apr 24, 2015 7:37 am

Had same problem with my F35. The front seal had moved forward releasing tension on the carbon/graphite bearing. I just loosened the set screws and compressed the bellows about 1 inch and retightened set screws. Don't forget there are two set screws, one on top of the other.
fmolden
 
Posts: 32
Joined: Thu Dec 04, 2008 11:39 am
Location: F35, S/V VOLANT, Rock Hall, MD


Return to Engines and Mechanical Systems

Who is online

Users browsing this forum: No registered users and 3 guests