Last season our jib traveler car broke and today we were able to replace it. We have been sailing without the jib traveler car for a while and had removed the blocks that it ran through. Unfortunately, we can't figure out where the jib sheet is supposed run through. Any chance someone can either take a picture of their setup or describe where the sheet runs starting from the clutch in the cockpit? We have the setup with a camberspar.
Thanks for your help,
Riki
40/40 jib traveler rigging
40/40 jib traveler rigging
1997 Freedom 40/40 Hull #27
Re: 40/40 jib traveler rigging
We re-rigged it with single blocks on both sides, but it still doesn't seem quite right. Could someone take a picture of their jib traveler setup and post it or send it to me?
It would be much appreciated!
Riki
It would be much appreciated!
Riki
1997 Freedom 40/40 Hull #27