Search found 315 matches
- Sun Jun 11, 2023 10:59 pm
- Forum: Everything Else
- Topic: F30 Bottom Paint Estimate
- Replies: 6
- Views: 3554
Re: F30 Bottom Paint Estimate
3/4 per coat for my F-33. Did 4 coats...
- Sun Jun 11, 2023 9:36 pm
- Forum: Everything Else
- Topic: And it begins
- Replies: 176
- Views: 53504
Re: And it begins
Well. Had to take a more drastic route. Removed a section where the front mounts go. Will get some 1/2 plate steel to go beneath and support with some angle iron/aluminum. Will drop the overall front 1.5 inches and allow me to match angles with the motor and shaft.
- Sun Jun 11, 2023 8:13 pm
- Forum: Everything Else
- Topic: And it begins
- Replies: 176
- Views: 53504
Re: And it begins
New problem.
Shaft is at 13.1 degrees
Motor is at 17.8 degrees.
Will try lowering the front to see what I get.
Shaft is at 13.1 degrees
Motor is at 17.8 degrees.
Will try lowering the front to see what I get.
- Sun Jun 11, 2023 8:02 pm
- Forum: Everything Else
- Topic: And it begins
- Replies: 176
- Views: 53504
Re: And it begins
A few on-site mods but it's there. Will do another mockup taking into account the close proximity of the stock motor mounts.
- Sun Jun 11, 2023 6:10 pm
- Forum: Everything Else
- Topic: And it begins
- Replies: 176
- Views: 53504
Re: And it begins
Motor template V6. AKA "USS Enterprise"
My back mounts sit higher than the front and it's tight against the hull. Now to load up the mockup, drive 30 miles and see if I am getting close.
My back mounts sit higher than the front and it's tight against the hull. Now to load up the mockup, drive 30 miles and see if I am getting close.
- Sat Jun 10, 2023 12:10 am
- Forum: Everything Else
- Topic: And it begins
- Replies: 176
- Views: 53504
Re: And it begins
I will get a more "final" photo once it's cleaned up and installed. Refocusing on pre engine installation.
- Fri Jun 09, 2023 8:37 pm
- Forum: Everything Else
- Topic: And it begins
- Replies: 176
- Views: 53504
Re: And it begins
Hmm guess I should paint back there before putting the motor in...
- Fri Jun 09, 2023 8:36 pm
- Forum: Everything Else
- Topic: And it begins
- Replies: 176
- Views: 53504
Re: And it begins
New shaft seal.
- Wed Jun 07, 2023 1:09 pm
- Forum: Everything Else
- Topic: Deck non skid
- Replies: 5
- Views: 2384
Re: Deck non skid
It sure beats mixing sand into paint. This will be my route (kiwi) once I get there.
- Tue Jun 06, 2023 11:20 pm
- Forum: Everything Else
- Topic: And it begins
- Replies: 176
- Views: 53504
Re: And it begins
Have the lower gudgeon in Anchorage. New brass bearing and clean up of the actual gudgeon being done. Nothing easy or cheap in Alaska. 12 hour drive and $1200 bill staring me in the face.