FreedomYachts.org

I have done it many times. The key is to pickup a quiet bay with no wakes and with shallow banks. It’s good to anchor in a deep spot of the bay and observe a low tide and exposed bottom. Pick the stop, relocate the boat into the spot on high tide, make sure it tilts toward higher ground on ongoing t...

Do you mean you have T track or T shaped slides with the track being square tube with a slot? I have f28 CK and my track is square. The slugs are T shaped. I do apply teflon dry spray grease couple times over a season. (Sailcote is expensive version of Teflon grease from west marine. The same grease...

If I were to repower my f28 ck. It is the way I actually explore since my yanmar 2qm15 is about to die. I invested quite a lot of thinking into process I would get rid of steering wheel and get back to tiller thinking. I have seen some original drawing of F 28. It called for tiller steering and outb...

Once mast is removed there is a hole in the center of the cast ring. The hole would allow the access to the retaining bolts and nuts under the plate.
At least it is how it's done on my boat.

John. It is possible to extend one setee to centerboard trank. The birth will be big enough for two very close people. :) I have never had 5 persons on board, but i slept many times in cockpit or in hammock between masts. Just look for camping hummock ( it is cross between tent and hammock, it has m...

On my boat the problem disappear after cleaning and tightening ground connection between battery and engine block.

Could it be some vent fitting? I vent my composting head into mizzen mast, it works well. Is there any hose inside of the mast?

I have F28CK with convenient booms and sail tracks. Batten end caps are on a luff and are not connected to the cars, sliders in my case. Sliders are located about 6 inches above and below a batten. Boom's goose-neck is on a relatively long bracket and it can swing past 90 degrees without hitting a m...

last ones

More pics