Posted by ereiss (ereiss@…>)
Any suggestions? Same stuff is needed for the propane locker lid.
thank you
Ed Reiss
Being There
F38 #154
out of Jamestown, RI
Posted by Bob Weeks (rweeks6508@…>)
Ed
Ok you are the one see my last email send
me your measurements and I will make a trip to the attic. I used the stuff I
had that was recommended for my cockpit locker and propane locker. My propane
locker I had to do a little different since the lid sat flat on the combing so
I create a contact from the side of the combing which then touches the inside
of the lid when closed.
Bob
From: FreedomOwnersGroup@yahoogroups.com [mailto:FreedomOwnersGroup@yahoogroups.com] On Behalf Of ereiss
Sent: Saturday, December 13, 2008
8:08 PM
To: FreedomOwnersGroup@yahoogroups.com
Subject: [FreedomOwnersGroup]
Source needed for Neoprene foam seals on Lazarette lid
Any suggestions? Same stuff is needed for the propane
locker lid.
thank you
Ed Reiss
Being There
F38 #154
out of Jamestown, RI
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.176 / Virus Database: 270.9.17/1846 - Release Date: 12/12/2008 6:59 PM